Which settings are required on a Xerox device before installing Drivve | Image on the device?
Before installing Drivve | Image on a Xerox device, you have to configure certain settings on the Xerox device. These settings are described in this article.
Note
For the following step instructions, the following Xerox device type has been used:
Xerox WorkCentre 7830 (
ConnectKey device).
Note: Enabling EIP on Xerox devices
For information on how to enable EIP on Xerox devices, consult the following document:
Xerox EIP.pdf
Proceed as follows:
- Enter the IP address of your Xerox device into your web browser.
The device administration page is displayed.
- Log in as administrator.
You have to install a certificate on the device. You can use either a purchased certificate or a certificate you have created (self signed certificate):
- If you wish to create a self signed certificate, continue with step 3.
- If you wish to use a purchased certificate, continue with step 6.
- Select the menu item Security> Certificates > Security Certificates.
- Click the button Create New Xerox Device Certificate.
- Enter the required data of the certificate and click Finish button.
- Select the menu item Connectivity > Setup.
- For the protocols HTTP and SNMP, click the Edit button und configure the required settings. The settings are described in the following sections.
HTTP settings
In the drop-down list Choose Device Certificate, select a device certificate and click the View/Save button.
Enable the options Enable and No (Requests can be made over HTTP and HTTPS), then click the Save button.
SNMP settings
Click the button Edit SNMP v1/v2c Properties and enable the SNMP protocols v1/v2c. Then click the Save button.
- Select the menu item Connectivity > Printing > Printing Web Services.
- Tick the framed options displayed in the following two figures, then click the Apply button.
- Select the menu item General Setup > Extensible Service Setup.
- Click the Edit button and enable the Extensible Service Registration. Tick the checkbox Enable the Extensible Services Browser and click the Apply button.
- Select the menu item Services > Custom Services > Weblet Management.
- Click the Edit button and enable the function Extensible Services Browser.
- Restart the Xerox device.